ATECO 2007 code — superseded in ATECO 2025
This code was remapped to:
- 24.33.02— Profilatura mediante formatura o piegatura a freddo di pannelli stratificati(corrispondenza diretta)
Recommended INPS scheme:
SEPARATA
Flat-rate scheme (forfettario)
Eligible for the flat-rate scheme?
Yes
Threshold:
€85,000
Profitability coefficient:
67%
Calculate your taxes
Classification
- CATTIVITÀ MANIFATTURIERE
- 24METALLURGIA
- 24.3FABBRICAZIONE DI ALTRI PRODOTTI DELLA PRIMA TRASFORMAZIONE DELL'ACCIAIO
- 24.33.0Profilatura mediante formatura o piegatura a freddo; fabbricazione di pannelli stratificati in acciaio
- 24.33.01Fabbricazione di pannelli stratificati in acciaio
Frequently asked questions
I cold roll-form open profiles and profiled sheets from steel strip: code 24.33.01 or sandwich panels 24.33.02?
24.33.01. This heading covers open-section profiles obtained by progressive deformation on a roll-forming line or press brake, and profiled sheets formed or bent cold. If instead you manufacture insulated sandwich panels, the code is 24.33.02.
I make profiled roofing sheets and then fit them on site: do I stay in 24.33.01 or does it become construction?
The manufacture of the profiled sheet remains 24.33.01. On-site installation and fixing are separate construction activities. If instead you bend steel reinforcement bar in a workshop, the activity is rebar bending 24.33.03.
I start from coil, first cold re-roll it, then roll-form it into profiles: is it a single code 24.33.01 or two activities?
The roll-forming into profiles and open sections is 24.33.01. Cold re-rolling of narrow flat strip, if carried out as a distinct stage, is instead 24.32.00. When you bend the strip into sections and profiled sheets, the activity that defines you is this one.